Channel-Member - Dell Z9500 Reference Manual

NOTE: The Dell Networking OS implementation of LAG or Port Channel requires that you configure
a LAG on both switches manually. For information about Dell Networking OS link aggregation
control protocol (LACP) for dynamic LAGs, refer to the
chapter. For more information about configuring and using Port Channels, refer to the Dell
Networking OS Configuration Guide.

channel-member

Add an interface to the Port Channel, while in INTERFACE PORTCHANNEL mode.
Z9500
Syntax
channel-member interface
To delete an interface from a Port Channel, use the no channel-member
interface command.
Parameters
interface
Defaults Not configured.
Command INTERFACE PORTCHANNEL
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.7(0.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.5.1.0
8.3.7.0
8.1.1.0
7.6.1.0
860
Link Aggregation Control Protocol (LACP)
(OPTIONAL) Enter any of the following keywords and slot/
port or number information:
• For a 100/1000 Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
Description
Introduced on the S6000-ON.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Added support for 4-port 40G line cards on ExaScale.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Interfaces