Siemens G130 List Manual page 1511

F02152 (A) TEC: insufficient memory
Message value: %1
Message class: Hardware/software error (1)
Drive object: All objects
Component: None
Reaction: OFF1
Acknowledge: IMMEDIATELY (POWER ON)
Cause: Too many functions have been configured on this Control Unit (e.g. too many drives, function modules, data sets,
Technology Extensions, blocks, etc).
Fault value (r0949, interpret decimal):
Only for internal Siemens troubleshooting.
Remedy: - change the configuration on this Control Unit (e.g. fewer drives, function modules, data sets, Technology
Extensions, blocks, etc).
- use an additional Control Unit.
Note:
TEC: Technology Extension
Reaction upon A: NONE
Acknowl. upon A: NONE
F02153 TEC: technology function does not exist
Message value: -
Message class: Hardware/software error (1)
Drive object: All objects
Component: None
Reaction: NONE
Acknowledge: IMMEDIATELY
Cause: A technology function (e.g. Technology Extension, DCB library) does not exist on the drive device.
When configuring, a technology function is activated, which does not exist on the drive device. This can occur when
downloading a project or when powering up.
Remedy: - load the required technology function to the drive device.
- if required, deactivate the technology function not required in the configuration.
Note:
DCB: Drive Control Block
TEC: Technology Extension
F03000 NVRAM fault on action
Message value: %1
Message class: Hardware/software error (1)
Drive object: All objects
Component: Control Unit (CU)
Reaction: NONE
Acknowledge: IMMEDIATELY
Cause: A fault occurred during execution of action p7770 = 1 or 2 for the NVRAM data.
Fault value (r0949, interpret hexadecimal):
yyxx hex: yy = fault cause, xx = application ID
yy = 1:
The action p7770 = 1 is not supported by this version if Drive Control Chart (DCC) is activated for the drive object
concerned.
yy = 2:
The data length of the specified application is not the same in the NVRAM and the backup.
yy = 3:
The data checksum in p7774 is not correct.
yy = 4:
No data available to load.
See also: p7770 (NVRAM action)
SINAMICS G130/G150
List Manual (LH2), 07/2016, A5E03263479A
Propagation: GLOBAL
Propagation: LOCAL
Propagation: LOCAL
4 Faults and alarms
4.2 List of faults and alarms
1511