Siemens G130 List Manual page 1492

4 Faults and alarms
4.2 List of faults and alarms
Note:
To: Time of setpoint acceptance
Tdx: Data exchange time
Reaction upon F: NONE (OFF1)
Acknowl. upon F: IMMEDIATELY
A01925 (F) Modbus TCP: connection interrupted
Message value: -
Message class: Communication error to the higher-level control system (9)
Drive object: CU_G130_DP, CU_G130_PN, CU_G150_DP, CU_G150_PN
Component: None
Reaction: NONE
Acknowledge: NONE
Cause: The Ethernet connection to the Modbus controller is interrupted.
Remedy: - establish an Ethernet connection.
- activate the Modbus controller.
Reaction upon F: NONE
Acknowl. upon F: IMMEDIATELY
A01930 PB/PN: current controller sampling time clock cycle synch. not equal
Message value: %1
Message class: Error in the parameterization / configuration / commissioning procedure (18)
Drive object: All objects
Component: None
Reaction: NONE
Acknowledge: NONE
Cause: The current controller sampling time of all drives must be set the same for the clock cycle synchronous operation.
Alarm value (r2124, interpret decimal):
Number of the drive object with different current controller sampling time.
Remedy: Set current controller sampling time to identical values (p0115[0]).
Note:
PB: PROFIBUS
PN: PROFINET
See also: p0115
A01931 PB/PN: speed controller sampling time clock cycle synch. not equal
Message value: %1
Message class: Error in the parameterization / configuration / commissioning procedure (18)
Drive object: All objects
Component: None
Reaction: NONE
Acknowledge: NONE
Cause: The speed controller sampling time of all drives must be set the same for the clock cycle synchronous operation.
Alarm value (r2124, interpret decimal):
Number of the drive object with the different speed controller sampling time.
Remedy: Set the speed controller sampling times to identical values (p0115[1]).
Note:
PB: PROFIBUS
PN: PROFINET
See also: p0115
1492
Propagation: LOCAL
Propagation: GLOBAL
Propagation: LOCAL
List Manual (LH2), 07/2016, A5E03263479A
SINAMICS G130/G150