Siemens G130 List Manual page 1366

4 Faults and alarms
4.1 Overview of faults and alarms
• LOCAL
Reaction: Default fault reaction (adjustable fault reaction)
Specifies the default reaction in the event of a fault.
The optional parentheses indicate whether the default fault reactions can be changed and
which fault reactions can be adjusted via parameters (p2100, p2101).
Note
See Table "Fault reactions" (Page 1357).
Acknowledgment: Default acknowledgment (adjustable acknowledgment)
Specifies the default method of acknowledging faults after the cause has been eliminated.
The optional parentheses indicate whether the default acknowledgment can be changed and
which acknowledgment can be adjusted via parameters (p2126, p2127).
Note
See Table "Acknowledging faults" (Page 1359).
Cause:
Describes the possible causes of the fault or alarm. A fault or alarm value can also be specified
(optional).
Fault value (r0949, format):
The fault value is entered into the fault buffer in r0949[0...63] and specifies additional, more
precise information about a fault.
Alarm value (r2124, format):
The alarm value specifies additional, more precise information about an alarm.
The alarm value is entered in the alarm buffer in r2124[0...7] and specifies additional, more
precise information about an alarm.
Remedy:
Description of the methods available for eliminating the cause of the active fault/alarm.
In certain cases, servicing and maintenance personnel are responsible for choosing a
suitable method for eliminating the cause of faults.
1366
The response of this type of propagation is dependent on parameter p3116.
With binector input p3116 = 0 (factory setting) the following applies:
The fault is passed on to the first active drive object with closed-loop control functions.
With binector input p3116 = 1-signal, the following applies:
The fault is not passed on.
WARNING
SINAMICS G130/G150
List Manual (LH2), 07/2016, A5E03263479A