Siemens G130 List Manual page 1390

4 Faults and alarms
4.2 List of faults and alarms
See also: p3109 (UTC synchronization tolerance)
Remedy: Select the synchronization intervals shorter so that the deviation between the time of day master and drive system
lies within the tolerance.
Note:
The deviation when synchronizing is shown in r3107.
See also: r3107 (UTC synchronization time out of tolerance)
Reaction upon N: NONE
Acknowl. upon N: NONE
A01100 CU: Memory card withdrawn
Message value: -
Message class: General drive fault (19)
Drive object: B_INF, VECTOR_G
Component: Control Unit (CU)
Reaction: NONE
Acknowledge: NONE
Cause: The memory card (non-volatile memory) was withdrawn during operation.
Notice:
It is not permissible for the memory card to be withdrawn or inserted under voltage.
Remedy: - switch off the drive system.
- re-insert the memory card that was withdrawn - this card must match the drive system.
- switch on the drive system again.
F01105 (A) CU: Insufficient memory
Message value: %1
Message class: Error in the parameterization / configuration / commissioning procedure (18)
Drive object: All objects
Component: Control Unit (CU)
Reaction: OFF1
Acknowledge: POWER ON
Cause: Too many functions have been configured on this Control Unit (e.g. too many drives, function modules, data sets,
Technology Extensions, blocks, etc).
Fault value (r0949, interpret decimal):
Only for internal Siemens troubleshooting.
Remedy: - change the configuration on this Control Unit (e.g. fewer drives, function modules, data sets, Technology
Extensions, blocks, etc).
- use an additional Control Unit.
Reaction upon A: NONE
Acknowl. upon A: NONE
F01106 CU: Insufficient memory
Message value: %1
Message class: Hardware/software error (1)
Drive object: B_INF, TM150, VECTOR_G
Component: Control Unit (CU)
Reaction: NONE
Acknowledge: IMMEDIATELY
Cause: There is not sufficient free memory space available.
Remedy: Not necessary.
1390
Propagation: LOCAL
Propagation: GLOBAL
Propagation: GLOBAL
List Manual (LH2), 07/2016, A5E03263479A
SINAMICS G130/G150