Siemens G130 List Manual page 1365

Table 4-4 Message classes and coding of various diagnostic interfaces, continued
Text of the message class (number according to PROFIdrive)
Cause and remedy.
Error in the parameterization/configuration/commissioning
procedure (18)
An error was identified in the parameterization or in a commissioning
procedure, or the parameterization does not match the actual device
configuration. Determine the precise cause of the fault using the
commissioning tool. Adapt the parameterization or device
configuration.
General drive fault (19)
Group fault. Determine the precise cause of the fault using the
commissioning tool.
Auxiliary unit fault (20)
The monitoring of an auxiliary unit (incoming transformer, cooling
unit ...) has detected an illegal state. Determine the exact cause of the
fault and check the relevant device.
1. Undervoltage condition of the electronics power supply
2. Overvoltage condition of the electronics power supply
Drive object:
Each message (fault/alarm) specifies the drive object in which it can be found.
A message can belong to either one, several, or all drive objects.
Component
Type of hardware component that has triggered the fault or alarm.
With "Component: None" it is not possible to assign the message to a hardware component.
Propagation
In the case of faults that are, for example, triggered by the Control Unit or a Terminal Module,
central functions of the drive are also often affected. Using propagation, faults that are
triggered by one drive object are therefore passed on to other drive objects.
There are the following types of propagation:
• BICO
• DRIVE
• GLOBAL
SINAMICS G130/G150
List Manual (LH2), 07/2016, A5E03263479A
The fault is passed on to all active drive objects with closed-loop control functions (infeed,
drive) to which there is a BICO interconnection.
The fault is passed on to all active drive objects with closed-loop control functions.
The fault is passed on to all active drive objects.
4.1 Overview of faults and alarms
Diagnostics interface
PN DS1 DP
(hex) (dec) (dec)
9011 17 31
9012 18 9
9013 19 29
4 Faults and alarms
ET 200 NAMUR
(dec) (r3113.x)
16 15
9 15
26 15
1365