Configuring X-On/X-Off Protocol - Alcatel-Lucent OmniSwitch 9800E Hardware User's Manual
Omniswitch 9000e series
Hide thumbs
Also See for OmniSwitch 9800E:
- Management manual (312 pages) ,
- Network configuration manual (1162 pages) ,
- Cli reference manual (3706 pages)
Table of Contents
Advertisement
Chassis Management Module (CMM)
Configuring X-ON/X-OFF Protocol
By default, the X-ON/X-OFF protocol is enabled on the console port. To enable and disable the X-ON/X-
OFF protocol on a console port that you are logged into use the
session xon-xoff followed by either enable or disable.
For example, to disable X-ON/X-OFF on a console port enter:
-> session xon-xoff disable
Note. To enable or disable the X-ON/X-OFF protocol on the secondary CMM, you must log into the
secondary CMM and then execute the session xon-xoff command.
OmniSwitch 9000E Series Hardware Users Guide
session xon-xoff
December 2008
CMM Front Panel
command by entering
page 3-9
Advertisement
Table of Contents
