01–8
Shape (Example)
WRONG
AVENSIS REPAIR MANUAL (RM1018E)
INTRODUCTION
(h)
REMOVAL AND INSTALLATION OF VACUUM HOSES
(1)
CORRECT
D25063
(2)
(3)
(4)
D25064
http://vnx.su
–
REPAIR INSTRUCTION
Removal/Installation
Removal
Removal
To disconnect vacuum hoses, pull them by holding
the end, not the middle of the hose.
When disconnecting vacuum hoses, use tags to
identify where they should be reconnected.
After completing the job, make a double check
whether the vacuum hoses are properly connected.
A label under the hood shows the proper layout.
When using a vacuum gauge, never force the hose
onto a connector that is too large. Use a step–down
adapter for adjustment. Once the hose has been
stretched, it may leak air.
Installation
Installation
V00012