Input Shaft And Clutch - Toyota 4-Runner 1985 Repair Manual

AUTOMATIC TRANSMISSION - Component Groups (Overdrive Input Shaft and Clutch) AT-39
Overdrive Input Shaft and Clutch
Piston Return Spring
00 Clutch Piston
00 Clutch Drum
Thrust Washer
Outer Race Disc
Thinner
Snap Ring
Snap Ring
00 Brake Hub
Thrust Washer
Plate
Snap Ring Thrust Washer
One-Way Clutch Planetary Gear
1<
AT0037
DISASSEMBLY OF OVERDRIVE INPUT SHAFT AND
CLUTCH
1. REMOVE THRUST BEARINGS AND RACES FROM OVER-
DRIVE INPUT SHAFT
(a) Slide off the thrust bearing and race from the clutch
side by hand. Note the position of the races.
(b) Using a screwdriver, pry off the thrust washer from
the planetary gear side.
2. PULL OVERDRIVE CLUTCH ASSEMBLY FROM INPUT
SHAFT
CAUTION: Be careful that the thrust bearing and race do
not fall out.
3. REMOVE THRUST BEARING AND RACE
Note the position of the
race.