Ci: Si Safety Control Channel Control Word S_Stw1B / Scc S_Stw1B; Co/Bo: Si Safety Control Channel Control Word S_Stw1B Diagnostics; Profisafe Telegram Selection / Ps Telegram_Sel - Siemens SINAMICS G150 Manual

2 Parameters
2.2 List of parameters
Value: 0:
1:
2:
3:
4:
5:
6:
7:
8:
9:
10:
11:
12:
13:
14:
15:
16:
p10250

CI: SI Safety Control Channel control word S_STW1B / SCC S_STW1B

VECTOR_G Can be changed: T
Data type: Unsigned32 / Integer16
P-Group: -
Not for motor type: -
Min
-
Description: Sets the signal source for control word S_STW1B of the Safety Control Channel.
Dependency: Refer to: p10203, r10251
Note: SCC: Safety Control Channel
r10251.8...12

CO/BO: SI Safety Control Channel control word S_STW1B diagnostics /

SCC S_STW1B diag
VECTOR_G Can be changed: -
Data type: Unsigned32
P-Group: -
Not for motor type: -
Min
-
Description: Display and BICO output for the diagnostics of control word S_STW1B of the safety control channel.
Bit field: Bit
08
09
10
12
Dependency: Refer to: p10250
Note: SCC: Safety Control Channel
p60022

PROFIsafe telegram selection / Ps telegram_sel

VECTOR_G Can be changed: T
Data type: Unsigned16
P-Group: Safety Integrated
Not for motor type: -
Min
0
Description: Sets the telegram number for PROFIsafe.
1000
Brake test inactive, wait for SBT selection
Setpoint input drive
Determining the load
Brake test is initialized, wait for start of test sequence
Start test seq
Closing the brake, establishing the test torque
Brake test active, wait for test duration sequence
Reduce test torque
Wait for the brake to open
Brake test successfully completed, wait for start deselection
Change to brake test initialized - fault acknowledgment
Brake test canceled, torque is reduced
Brake test canceled, wait for brake to open
Brake test ended with error, wait for acknowledgment
Brake opening timer elapsed
Error when initializing the brake test, wait for acknowledgment
Change to brake test inactive, acknowledgment active
Signal name
Extended functions test stop selection
Extended Functions referencing trigger
Extended Functions referencing reset
Extended Functions premature SOS after
STOP D
Calculated: -
Dyn. index: -
Units group: -
Scaling: -
Max
-
Calculated: -
Dyn. index: -
Units group: -
Scaling: -
Max
-
1 signal
Selected
Selected
Selected
Selected
Calculated: -
Dyn. index: -
Units group: -
Scaling: -
Max
902
List Manual (LH2), 04/2014, A5E03263479A
Access level: 3
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
0
Access level: 3
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
-
0 signal
Not selected
Not selected
Not selected
Not selected
Access level: 3
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
0
SINAMICS G130/G150
FP
2837
-
-
-