Siemens SINAMICS G List Manual page 87

p0430[0...n] Sensor module configuration / SM configuration
VECTOR Can be changed: C2
Data type: Unsigned32
P-Group: Encoder
Min
0000 bin
Description: Sets the configuration of the sensor module.
Bit field: Bit Signal name
17 Burst oversampling
19 Safety position actual value sensing
29 Phase correction
30 Amplitude correction
31 Offset correction
p0431[0...n] Commutation angle offset / Com_offset
VECTOR Can be changed: C2
Data type: Floating Point
P-Group: Encoder
Min
-180.00 [°]
Description: Sets the commutation angular offset.
p0432[0...n] Gearbox factor, numerator / Gearb_fact numer
VECTOR Can be changed: C2
Data type: Integer16
P-Group: Encoder
Min
1
Description: Enters the numerator for the gearbox factor of the encoder evaluation.
The gearbox factor specifies the speed ratio between the encoder shaft and motor shaft.
Note: Negative gearbox factors should be implemented with p0410.
p0433[0...n] Gearbox factor, denominator / Gearb_fact denom
VECTOR Can be changed: C2
Data type: Integer16
P-Group: Encoder
Min
1
Description: Enters the denominator for the gearbox factor of the encoder evaluation.
The gearbox factor specifies the speed ratio between the encoder shaft and motor shaft.
Note: Negative gearbox factors should be implemented with p0410.
 Siemens AG 2004 All Rights Reserved
SINAMICS G List Manual, Edition 12.2004
Data set: EDS
Units group: -
Max
1110 0000 0000 1010 0000 0000
0000 0000 bin
0 signal
No
No
No
No
No
Data set: EDS
Units group: ANGLE
Max
180.00 [°]
Data set: EDS
Units group: -
Max
10000
Data set: EDS
Units group: -
Max
10000
Parameters
Parameter list
Access level: 3
Function diagram: -
Unit selection: -
Factory setting
1110 0000 0000 0000 0000
0000 0000 0000 bin
1 signal FP
Yes -
Yes -
Yes -
Yes -
Yes -
Access level: 3
Function diagram: -
Unit selection: -
Factory setting
0.00 [°]
Access level: 3
Function diagram: -
Unit selection: -
Factory setting
1
Access level: 3
Function diagram: -
Unit selection: -
Factory setting
1
1-87