Siemens SINAMICS G List Manual page 196

Parameters
Parameter list
Note: This parameter can be freely interconnected.
The value has the above significance if it is interconnected from connector input p1528.
r1526 Torque limit, upper/motoring without offset / M_max up. w/o offs
VECTOR (n/M) Can be changed: -
Data type: Floating Point
P-Group: Control
Min
- [Nm]
Description: Displays the upper torque/force limit of all torque/force limits without offset.
Dependency: p1400 bit 4 = 0: top / bottom
p1400 bit 4 = 1: motoring / regenerating
Refer to: p1520, p1521, p1522, p1523
r1527 Torque limit, lower/regenerative without offset / M_max low w/o offs
VECTOR (n/M) Can be changed: -
Data type: Floating Point
P-Group: Control
Min
- [Nm]
Description: Displays the lower torque/force limit of all torque/force limits without offset.
Dependency: p1400 bit 4 = 0: top / bottom
p1400 bit 4 = 1: motoring / regenerating
Refer to: p1520, p1521, p1522, p1523
p1528[0...n] CI: Torque limit upper scaling / M_max upper scal
VECTOR (n/M) Can be changed: T
Data type: Unsigned32
P-Group: Control
Min
-
Description: Sets the signal source for the scaling of the upper torque limit in p1522.
p1529[0...n] CI: Torque limit lower scaling / M_max lower scal
VECTOR (n/M) Can be changed: T
Data type: Unsigned32
P-Group: Control
Min
-
Description: Sets the signal source for the scaling of the lower torque limit in p1523.
p1530[0...n] Power limit, motoring / P_max mot
VECTOR (n/M) Can be changed: U, T
Data type: Floating Point
P-Group: Control
Min
0.00 [kW]
Description: Sets the power limit when motoring.
1-196
Data set: -
Units group: TORQUE
Max
- [Nm]
Data set: -
Units group: TORQUE
Max
- [Nm]
Data set: CDS
Units group: -
Max
-
Data set: CDS
Units group: -
Max
-
Data set: DDS
Units group: POWER_P3
Max
10000.00 [kW]
 Siemens AG 2004 All Rights Reserved
SINAMICS G List Manual, Edition 12.2004
Access level: 3
Function diagram: 5620,
5630, 6630, 6640
Unit selection: -
Factory setting
- [Nm]
Access level: 3
Function diagram: 5620,
5630, 6630, 6640
Unit selection: -
Factory setting
- [Nm]
Access level: 3
Function diagram: 6630
Unit selection: -
Factory setting
1524[0]
Access level: 3
Function diagram: 6630
Unit selection: -
Factory setting
1525[0]
Access level: 2
Function diagram: 5640,
6640
Unit selection: -
Factory setting
0.00 [kW]