Table of Contents
Advertisement
Parameters
Parameter list
Note:
The parameter is automatically preset for motors from the motor list (p0301). For synchronous motors (p0300 =
2xx), the parameter can be optionally input.
For servo drives, the following applies:
For synchronous motors, the parameter is of no significance from a control-related perspective.
For vector drives, the following applies:
if the rated voltage is entered for synchronous motors during the commissioning phase, then the stator leakage
inductance (p0356, p0357) can be more accurately calculated (refer to p0340 and p03900).
p0305[0...n]
Rated motor current / Mot I_rated
VECTOR
Can be changed: C2
Data type: Floating Point
P-Group: Motor
Min
0.00 [Aeff]
Description:
Sets the rated motor current (rating plate).
Notice:
For vector drives (refer to p0107):
If the rated motor current exceeds twice the maximum drive converter current (r0209), then the maximum current is
reduced due to the current harmonics that increase overproportionally (r0067).
Note:
The parameter is not used for synchronous motors (p0300 = 2xx).
The parameter is automatically preset for motors from the motor list (p0301).
p0307[0...n]
Rated motor power / Mot P_rated
VECTOR
Can be changed: C2
Data type: Floating Point
P-Group: Motor
Min
0.00 [kW]
Description:
Sets the rated motor power (rating plate).
Dependency:
IEC drives (p0100 = 0): Units, kW
NEMA drives (p0100 = 1): Units, hp
Refer to: p0100
Note:
The parameter is automatically preset for motors from the motor list (p0301).
p0308[0...n]
Rated motor power factor / Mot CosPhi_rated
VECTOR
Can be changed: C2
Data type: Floating Point
P-Group: Motor
Min
0.000
Description:
Sets the rated motor power factor cos phi (rating plate).
For a parameter value of 0.000, the power factor is internally calculated and displayed in r0332.
Dependency:
This parameter is only available for IEC motors (p0100 = 0).
Refer to: p0100, p0309, r0332
Note:
The parameter is not used for synchronous motors (p0300 = 2xx).
The parameter is automatically preset for motors from the motor list (p0301).
1-66
Data set: MDS
Units group: CURRENT_AC_EFF Unit selection: -
Max
10000.00 [Aeff]
Data set: MDS
Units group: POWER_P3
Max
10000.00 [kW]
Data set: MDS
Units group: -
Max
1.000
Siemens AG 2004 All Rights Reserved
SINAMICS G List Manual, Edition 12.2004
Access level: 1
Function diagram: 6300
Factory setting
0.00 [Aeff]
Access level: 1
Function diagram: -
Unit selection: p0100
Factory setting
0.00 [kW]
Access level: 1
Function diagram: -
Unit selection: -
Factory setting
0.000
Hide quick links:
Advertisement
Table of Contents
