Siemens SINAMICS G List Manual page 46

Parameters
Parameter list
Dependency: Refer to: p0103, r0107, p0107
Refer to: F01051
p0107[0...15] Drive object type / DO type
CU Can be changed: C1
Data type: Integer16
P-Group: -
Min
0
Description: The type of an existing drive object is entered into each index.
Values: 0:
1:
2:
3:
4:
5:
10:
11:
12:
13:
20:
30:
100:
200:
201:
202:
203:
254:
Dependency: Refer to: r0103, p0103, r0107
Refer to: F01051
Caution! If you change this parameter and exit the device commissioning mode, then the complete software will be set up
again and all of the previous drive parameter settings are deleted.
Note: The number (p0101) and the associated drive object type are in the same index.
For SINAMICS S a drive object type can only be changed between SERVO and VECTOR. If you change the
parameter and exit drive start-up (p0009 from 2 to 0) the drive parameters are set up again.
r0107 Drive object type / DO type
TB30, TM31, Can be changed: -
VECTOR
Data type: Integer16
P-Group: Control
Min
-
Description: Displays the type of each drive object.
Values: 10:
11:
12:
13:
20:
30:
100:
200:
201:
202:
203:
254:
Dependency: Refer to: r0103, p0103, p0107
Refer to: F01051
1-46
Not a type
SINAMICS S
SINAMICS G
SINAMICS I
SINAMICS CX32
SINAMICSGM
ACTIVE LINE MODULE
SERVO
VECTOR
VECTORMV
SMART LINE MODULE
BASIC LINE MODULE
TB30 (Terminal Board)
TM31 (Terminal Module)
TM41 (Terminal Module)
TM17 High Feature (Terminal Module)
TM15 (Terminal Module)
CU-LINK
ACTIVE LINE MODULE
SERVO
VECTOR
VECTORMV
SMART LINE MODULE
BASIC LINE MODULE
TB30 (Terminal Board)
TM31 (Terminal Module)
TM41 (Terminal Module)
TM17 High Feature (Terminal Module)
TM15 (Terminal Module)
CU-LINK
Data set: -
Units group: -
Max
254
Data set: -
Units group: -
Max
-
 Siemens AG 2004 All Rights Reserved
SINAMICS G List Manual, Edition 12.2004
Access level: 2
Function diagram: -
Unit selection: -
Factory setting
0
Access level: 2
Function diagram: -
Unit selection: -
Factory setting
-