Siemens SINAMICS G List Manual page 17

Data type
The possible data types of parameter values are as follows:
• I8
• I16
• I32
• U8
• U16
• U32
• Float
Data set
Parameters which are dependent on a data set are identified as follows:
• CDS (Command Data Set)
Example:
p1070[0]
p1070[1]
• DDS (Drive Data Set)
• EDS (Encoder Data Set)
• MDS (Motor Data Set)
• PDS (Power Module Data Set)
Note:
References: /IH1/
Function diagram
The parameter is included in this function diagram. The structure of the parameter
function and its interrelationship with other parameters is shown in the specified
function diagram.
Example:
Function diagram: 3060.3
 Siemens AG 2004 All Rights Reserved
SINAMICS G List Manual, Edition 12.2004
Integer8 8-bit integer
Integer16 16-bit integer
Integer32 32-bit integer
Unsigned8 8 bits without sign
Unsigned16 16 bits without sign
Unsigned32 32 bits without sign
FloatingPoint Floating point number
main setpoint [command data set 0]
main setpoint [command data set 1], etc.
SINAMICS S120 Commissioning Manual
in section "Data Sets"
3060:
3:
Overview of parameters
Function diagram number
Signal path (optional)
Parameters
1-17