Siemens SINAMICS G List Manual page 257

r2123[0...7] Alarm time received in milliseconds / t_alarm recv ms
All objects Can be changed: -
Data type: Unsigned32
P-Group: Messages
Min
-
Description: Displays the system runtime in milliseconds when the alarm occurred.
Dependency: Refer to: r2110, r2114, r2122, r2124, r2125, r2134, r2145, r2146
r2124[0...7] Alarm value / Alarm value
All objects Can be changed: -
Data type: Integer32
P-Group: Messages
Min
-
Description: Displays additional information about the active alarm (as integer number).
Dependency: Refer to: r2110, r2122, r2123, r2125, r2134, r2145, r2146
r2125[0...7] Alarm time removed in milliseconds / t_alarm res ms
All objects Can be changed: -
Data type: Unsigned32
P-Group: Messages
Min
-
Description: Displays the system runtime in milliseconds when the alarm was cleared.
Dependency: Refer to: r2110, r2114, r2122, r2123, r2124, r2134, r2145, r2146
p2126[0...19] Setting fault number for acknowledge mode / Fault_no ackn_mode
All objects Can be changed: U, T
Data type: Unsigned16
P-Group: Messages
Min
0
Description: Selects the faults for which the acknowledge mode is to be changed
Dependency: Selects the faults and sets the required acknowledge mode realized under the same index
Refer to: p2127
Notice: It is not possible to re-parameterize the acknowledge mode of a fault in the following cases:
- if there is no existing fault number.
- the message type is not "fault" (F).
- when a fault is present.
 Siemens AG 2004 All Rights Reserved
SINAMICS G List Manual, Edition 12.2004
Data set: -
Units group: -
Max
-
Data set: -
Units group: -
Max
-
Data set: -
Units group: -
Max
-
Data set: -
Units group: -
Max
65535
Parameters
Parameter list
Access level: 3
Function diagram: 1750,
8065
Unit selection: -
Factory setting
-
Access level: 3
Function diagram: 1750,
8065
Unit selection: -
Factory setting
-
Access level: 3
Function diagram: 1750,
8065
Unit selection: -
Factory setting
-
Access level: 3
Function diagram: 1750,
8075
Unit selection: -
Factory setting
0
1-257