Siemens SINAMICS G List Manual page 284

Parameters
Parameter list
p3950 Service parameter / Service parameter
CU Can be changed: C1, U, T
Data type: Unsigned16
P-Group: All groups
Min
0
Description: For service personnel only.
p3981 Faults, acknowledge drive object / Faults ackn DO
All objects Can be changed: U, T
Data type: Unsigned8
P-Group: Messages
Min
0
Description: Acknowledges all active faults of a drive object.
Note: Parameter should be set from 0 to 1 to acknowledge.
After acknowledgement, the parameter is automatically reset to 0.
p3985 Master control mode selection / PcCtrl mode select
VECTOR Can be changed: U, T
Data type: Integer16
P-Group: Setpoints
Min
0
Description: Sets the mode to change over the master control / local mode.
Values: 0:
1:
Danger! When changing the master control in operation, the drive can manifest undesirable behavior - e.g. it can accelerate
up to another setpoint.
r3986 No. of parameters / No. of parameters
All objects Can be changed: -
Data type: Unsigned16
P-Group: -
Min
-
Description: Displays the number of parameters for this drive unit.
The number comprises the device-specific and the drive-specific parameters.
Dependency: Refer to: r0980, r0981, r0989
r3988 Ramp-up state / Ramp-up state
CU Can be changed: -
Data type: Integer16
P-Group: -
Min
-
Description: Displays the ramp-up state.
1-284
Change master control for STW1.0 = 0
Change master control in operation
Data set: -
Units group: -
Max
65535
Data set: -
Units group: -
Max
1
Data set: -
Units group: -
Max
1
Data set: -
Units group: -
Max
-
Data set: -
Units group: -
Max
-
 Siemens AG 2004 All Rights Reserved
SINAMICS G List Manual, Edition 12.2004
Access level: 4
Function diagram: -
Unit selection: -
Factory setting
0
Access level: 2
Function diagram: 2501
Unit selection: -
Factory setting
0
Access level: 3
Function diagram: -
Unit selection: -
Factory setting
0
Access level: 3
Function diagram: -
Unit selection: -
Factory setting
-
Access level: 4
Function diagram: -
Unit selection: -
Factory setting
-