Siemens SINAMICS G List Manual page 210

Parameters
Parameter list
p1750[0...n] Motor model configuration / MotMod config
VECTOR (n/M) Can be changed: U, T
Data type: Unsigned8
P-Group: Control
Min
0000 bin
Description: Sets the configuration of the motor model.
Bit field: Bit Signal name
00 Controlled start
01 Controlled through 0 Hz
02 Set motor model
r1751 Motor model status / MotMod status
VECTOR (n/M) Can be changed: -
Data type: Unsigned16
P-Group: Control
Min
-
Description: Displays the status of the motor model.
Bit field: Bit Signal name
00 Controlled operation
01 Set ramp-function generator
02 Stop RsLh adaptation
03 Feedback
04 Encoder operation
05 Holding angle
06 Acceleration criteria
12 Rs adaptation waits
13 Motor operation
14 Stator frequency sign
15 Torque sign
p1752[0...n] Motor model changeover speed operation with encoder / MotMod n_chgov enc
VECTOR (n/M) Can be changed: U, T
Data type: Floating Point
P-Group: Control
Min
0.0 [1/min]
Description: Sets the speed/velocity to change over the motor model for operation with encoder.
Dependency: Refer to: p1756
p1755[0...n] Motor model changeover speed sensorless operation / MotMod n_chgSnsorl
VECTOR (n/M) Can be changed: U, T
Data type: Floating Point
P-Group: Control
Min
0.0 [1/min]
Description: Sets the speed/velocity to change over the motor model to sensorless operation (without encoder).
Dependency: Refer to: p1756
Note: The changeover speed applies for the changeover between open-loop and closed-loop control mode.
1-210
Data set: DDS
Units group: -
Max
0111 bin
0 signal
No
No
No
Data set: -
Units group: -
Max
-
0 signal
not active
not active
No
not active
not active
No
not active
No
No
Negative
Regenerative mode
Data set: DDS
Units group: SPEED_ROT
Max
210000.0 [1/min]
Data set: DDS
Units group: SPEED_ROT
Max
210000.0 [1/min]
 Siemens AG 2004 All Rights Reserved
SINAMICS G List Manual, Edition 12.2004
Access level: 3
Function diagram: -
Unit selection: -
Factory setting
0000 bin
1 signal FP
Yes -
Yes -
Yes -
Access level: 3
Function diagram: -
Unit selection: -
Factory setting
-
1 signal FP
active -
active -
Yes -
active -
active -
Yes -
active -
Yes -
Yes -
Positive -
Motor mode -
Access level: 3
Function diagram: -
Unit selection: -
Factory setting
210000.0 [1/min]
Access level: 3
Function diagram: -
Unit selection: -
Factory setting
210000.0 [1/min]