Siemens SINAMICS G List Manual page 258

Parameters
Parameter list
p2127[0...19] Sets acknowledgment mode / Acknowledge mode
All objects Can be changed: U, T
Data type: Integer16
P-Group: Messages
Min
1
Description: Sets the acknowledge mode for selected fault.
Values: 1:
2:
Dependency: Selects the faults and sets the required acknowledge mode realized under the same index
Refer to: p2126
Notice: It is not possible to re-parameterize the acknowledge mode for existing faults.
Note: 1: POWER ON (POWER_ON)
2: IMMEDIATELY
The acknowledge mode can only be changed for faults with the appropriate identification.
Example:
F12345 and acknowledge mode = POWER ON (IMMEDIATELY) --> The acknowledge mode can be changed from
POWER ON to IMMEDIATELY.
p2128[0...15] Selecting fault/alarm code for trigger / Message trigger
All objects Can be changed: U, T
Data type: Unsigned16
P-Group: Messages
Min
0
Description: Selects faults or alarms which can be used as trigger.
Dependency: Refer to: r2129
r2129 CO/BO: Trigger word for faults and alarms / Trigger word
All objects Can be changed: -
Data type: Unsigned16
P-Group: Messages
Min
-
Description: Trigger signal for the selected faults and alarms
Bit field: Bit Signal name
00 Trigger signal p2128[0]
01 Trigger signal p2128[1]
02 Trigger signal p2128[2]
03 Trigger signal p2128[3]
04 Trigger signal p2128[4]
05 Trigger signal p2128[5]
1-258
Acknowledgment is only possible using POWER ON
The fault can be IMMEDIATELY acknowledged after the cause has been removed
Data set: -
Units group: -
Max
2
Data set: -
Units group: -
Max
65535
Data set: -
Units group: -
Max
-
0 signal
Off
Off
Off
Off
Off
Off
 Siemens AG 2004 All Rights Reserved
SINAMICS G List Manual, Edition 12.2004
Access level: 3
Function diagram: 1750,
8075
Unit selection: -
Factory setting
1
Access level: 3
Function diagram: 1750,
8070
Unit selection: -
Factory setting
0
Access level: 3
Function diagram: 1530,
8070
Unit selection: -
Factory setting
-
1 signal FP
On -
On -
On -
On -
On -
On -