Table of Contents
Advertisement
Parameters
Parameter list
Note:
All indices of r9491 to p9493 designate the same interconnection. r9491[x] contains the signal receiver and r9492[x]
the matching signal source; p9493[x] can be set to modify the interconnection.
p9601
SI enables safety functions (control unit) / SI enable fct CU
VECTOR
Can be changed: C2
Data type: Unsigned32
P-Group: Safety Integrated
Min
0000 bin
Description:
Sets the enable signals for safety functions on the control unit.
Bit field:
Bit
Signal name
00
Enable SH via terminal (Control Unit)
Dependency:
Refer to: p9801
Note:
CU: Control unit
SH: Safe standstill
SI: Safety Integrated
p9602
SI enable safe brake control (control unit) / SI enable SBC CU
VECTOR
Can be changed: C2
Data type: Integer16
P-Group: Safety Integrated
Min
0
Description:
Sets the enable signal for the function "Safe brake control" (SBC) on the control unit.
Values:
0:
1:
Dependency:
Refer to: p9802
Note:
The "safe brake control" function is not activated until at least one safety monitoring function has been enabled (i.e.
p9601 not equal to 0).
CU: Control unit
SBC: Safe brake control
SI: Safety Integrated
p9620
BI: SI signal source for safe standstill (control unit) / SI select SH CU
VECTOR
Can be changed: C2
Data type: Unsigned32
P-Group: Safety Integrated
Min
-
Description:
Sets the signal source for the function "Safe standstill" (SH) on the control unit.
Dependency:
Refer to: p9601
Note:
The following signal sources are permitted:
- fixed zero (standard setting)
- digital inputs (DI 0 to DI 7 on the control unit
1-348
Inhibit SBC
Enable SBC
Data set: -
Units group: -
Max
0001 bin
0 signal
Inhibit
Data set: -
Units group: -
Max
1
Data set: -
Units group: -
Max
-
Siemens AG 2004 All Rights Reserved
SINAMICS G List Manual, Edition 12.2004
Access level: 3
Function diagram: -
Unit selection: -
Factory setting
0000 bin
1 signal
FP
Enable
2810
Access level: 3
Function diagram: 2814
Unit selection: -
Factory setting
0
Access level: 3
Function diagram: 2810
Unit selection: -
Factory setting
0
Hide quick links:
Advertisement
Table of Contents
