Siemens SINAMICS G List Manual page 133

Index: [0] = Header
[1] = Type, encoder 1
[2] = Resolution encod 1
[3] = Shift factor G1_XACT1
[4] = Shift factor G1_XACT2
[5] = Distinguishable revolutions encoder 1
[6] = Reserved
[7] = Reserved
[8] = Reserved
[9] = Reserved
[10] = Reserved
[11] = Type, encoder 2
[12] = Resolution encod 2
[13] = Shift factor G2_XACT1
[14] = Shift factor G2_XACT2
[15] = Distinguishable revolutions encoder 2
[16] = Reserved
[17] = Reserved
[18] = Reserved
[19] = Reserved
[20] = Reserved
[21] = Type, encoder 3
[22] = Resolution encod 3
[23] = Shift factor G3_XACT1
[24] = Shift factor G3_XACT2
[25] = Distinguishable revolutions encoder 3
[26] = Reserved
[27] = Reserved
[28] = Reserved
[29] = Reserved
[30] = Reserved
Note: Information on the individual indices should be taken from the PROFIdrive Profile Drive Technology.
r0980[0...99] List of existing parameters 1 / List avail par 1
All objects Can be changed: -
Data type: Unsigned16
P-Group: -
Min
-
Description: Displays the parameters that exist for this drive.
Dependency: Refer to: r0981, r0989
Note: The existing parameters are displayed in indices 0 to 98. If an index contains the value 0, then the list ends here. In
a long list, index 99 contains the parameter number at which position the list continues.
This list completely comprises the following parameters:
r0980[0...99], r0981[0...99] ... r0989[0...99]
The parameters in this list are not displayed in the expert list of the commissioning software. However, they can be
read from a higher-level control system (e.g. PROFIBUS master).
r0981[0...99] List of existing parameters 2 / List avail par 2
All objects Can be changed: -
Data type: Unsigned16
P-Group: -
Min
-
Description: Displays the parameters that exist for this drive.
Dependency: Refer to: r0980, r0989
 Siemens AG 2004 All Rights Reserved
SINAMICS G List Manual, Edition 12.2004
Data set: -
Units group: -
Max
-
Data set: -
Units group: -
Max
-
Parameters
Parameter list
Access level: 4
Function diagram: -
Unit selection: -
Factory setting
-
Access level: 4
Function diagram: -
Unit selection: -
Factory setting
-
1-133