Siemens SINAMICS G List Manual page 34

Parameters
Parameter list
16 OFF1 enable internal missing
17 OFF2 enable internal missing
18 OFF3 enable internal missing
19 Pulse enable internal missing
21 STOP2 enable internal missing
22 STOP1 enable internal missing
27 Demagnetization not completed
28 Brake open missing
30 Function generator with current input
31 Jog setpoint active
Dependency: Refer to: r0002
Note: The value r0046 = 0 indicates that all enable signals for this drive are present.
Bit 00 = 1 (enable signal missing), if:
- the signal source in p0840 is a 0 signal.
- there is a power-on inhibit.
Bit 01 = 1 (enable signal missing), if:
- the signal source in p0844 or p0845 is a 0 signal.
Bit 02 = 1 (enable signal missing), if:
- the signal source in p0848 or p0849 is a 0 signal.
Bit 03 = 1 (enable signal missing), if:
- the signal source in p0852 is a 0 signal.
Bit 05, bit 06: (being developed)
Bit 08 = 1 (enable signal missing), if:
- the pulse enable via terminal EP at the motor module is missing (X21.3, X21.4).
Bit 09 = 1 (enable signal missing), if:
- the signal source in p0864 is a 0 signal.
Bit 10 = 1 (enable signal missing), if:
- the signal source in p1140 is a 0 signal.
Bit 11 = 1 (enable signal missing) if the speed setpoint is frozen, because:
- the signal source in p1141 is a 0 signal or
- the speed setpoint is entered from jogging and the two signal sources for jogging, bit 0 (p1055) and bit 1 (p1056)
have a 1 signal.
Bit 12 = 1 (enable signal missing), if:
- the signal source in p1142 is a 0 signal.
Bit 16 = 1 (enable signal missing), if:
- there is an OFF1 fault response. The system is only enable if the fault is removed and was acknowledged and the
power-on inhibit withdrawn with OFF1 = 0.
Bit 17 = 1 (enable signal missing), if:
- the commissioning mode is selected (p0009 > 0 or p0010 > 0) or an OFF2 fault response is present.
Bit 18 = 1 (enable signal missing), if:
- OFF3 has still not be completed or an OFF3 fault response is present.
Bit 19 = 1 (internal pulse enable missing), if:
- synchronization is running between the basic clock cycle, DRIVE-CLiQ clock cycle and application clock cycle.
Bit 21 = 1 (enable signal missing), if:
The pulses have been enabled and the speed setpoint has still not been enabled, because:
- the holding brake opening time (p1216) has still not expired.
- The motor has still not been magnetized (induction motor).
Bit 22: Being developed
Bit 27 = 1 (enable signal missing), if:
- de-magnetizing has still not been completed (only for vector).
Bit 28 = 1 (enable signal missing), if:
- the holding brake is closed or has still not been opened.
Bit 31 = 1 (enable signal missing), if:
- the speed setpoint is entered from jogging 1 or 2.
1-34
No Yes
No Yes
No Yes
No Yes
No Yes
No Yes
No Yes
No Yes
not active active
No Yes
 Siemens AG 2004 All Rights Reserved
SINAMICS G List Manual, Edition 12.2004
-
-
-
-
-
-
-
-
-
-