Siemens SINAMICS G List Manual page 255

p2116[0...n] BI: External alarm 2 / External alarm 2
VECTOR Can be changed: U, T
Data type: Unsigned32
P-Group: Messages
Min
-
Description: Sets the signal source for external alarm 2.
Dependency: External alarm 2 --> A07851(F)
Refer to: A07851
Note: An external alarm is triggered with a 1/0 signal.
p2117 BI: External alarm 3 / External alarm 3
CU, TB30, TM31 Can be changed: U, T
Data type: Unsigned32
P-Group: Messages
Min
-
Description: Sets the signal source for external alarm 3.
Dependency: External alarm 3 --> A07852(F)
Refer to: A07852
Note: An external alarm is triggered with a 1/0 signal.
p2117[0...n] BI: External alarm 3 / External alarm 3
VECTOR Can be changed: U, T
Data type: Unsigned32
P-Group: Messages
Min
-
Description: Sets the signal source for external alarm 3.
Dependency: External alarm 3 --> A07852(F)
Refer to: A07852
Note: An external alarm is triggered with a 1/0 signal.
p2118[0...19] Sets the message number for message type. / Msg_no Msg_type
All objects Can be changed: U, T
Data type: Unsigned16
P-Group: Messages
Min
0
Description: Selects faults or alarms for which the message type should be changed.
Dependency: Selects the fault or alarm selection and sets the required type of message realized under the same index.
Refer to: p2119
Notice: It is not possible to re-parameterize the message type in the following cases:
- if there is no existing message number.
- if a message is present.
 Siemens AG 2004 All Rights Reserved
SINAMICS G List Manual, Edition 12.2004
Data set: CDS
Units group: -
Max
-
Data set: -
Units group: -
Max
-
Data set: CDS
Units group: -
Max
-
Data set: -
Units group: -
Max
65535
Parameters
Parameter list
Access level: 3
Function diagram: 2546
Unit selection: -
Factory setting
1
Access level: 3
Function diagram: -
Unit selection: -
Factory setting
1
Access level: 3
Function diagram: 2546
Unit selection: -
Factory setting
1
Access level: 3
Function diagram: 1750,
8075
Unit selection: -
Factory setting
0
1-255