Table of Contents
Advertisement
Parameters
Parameter list
r0313[0...n]
Motor pole pair number, actual (or calculated) / Mot PolePairNo act
VECTOR
Can be changed: -
Data type: Unsigned8
P-Group: Motor
Min
-
Description:
Displays the number of motor pole pairs. The value is used for internal calculations.
Values:
r0313 = 1: 2-pole motor
r0313 = 2: 4-pole motor
etc.
Dependency:
For p0314 > 0, the entered value is displayed in r0313.
For p0314 = 0, the pole pair number is automatically calculated from the rated frequency (p0310) and the rated
speed (p0311).
Refer to: p0310, p0311, p0314
Note:
For the automatic calculation, the pole pair number is set to the value of 2 if the rated speed or the rated frequency
is zero.
p0314[0...n]
Motor pole pair number / Mot pole pair No.
VECTOR
Can be changed: C2
Data type: Unsigned8
P-Group: Motor
Min
0
Description:
Sets the motor pole pair number.
Values:
p0314 = 1: 2-pole motor
p0314 = 2: 4-pole motor
etc.
Dependency:
For p0314 = 0, the pole pair number is automatically calculated from the rated frequency (p0310) and the rated
speed (p0311) and displayed in r0313.
Notice:
For induction motors, the value need only be input if the rated data of a generator is entered therefore resulting in a
negative rated slip. In this case, the number of pole pairs in r0313 is too low by 1 and must be manually corrected.
p0315[0...n]
Motor pole pair width / MotPolePair width
VECTOR
Can be changed: C2
Data type: Floating Point
P-Group: Motor
Min
1.00 [mm]
Description:
Sets the pole pair width of the linear motor.
Note:
The parameter is automatically preset for motors from the motor list (p0301).
1-68
Data set: MDS
Units group: -
Max
-
Data set: MDS
Units group: -
Max
127
Data set: MDS
Units group: LENGTH_M3
Max
1000.00 [mm]
Siemens AG 2004 All Rights Reserved
SINAMICS G List Manual, Edition 12.2004
Access level: 3
Function diagram: 5300
Unit selection: -
Factory setting
-
Access level: 1
Function diagram: -
Unit selection: -
Factory setting
0
Access level: 1
Function diagram: -
Unit selection: -
Factory setting
30.00 [mm]
Hide quick links:
Advertisement
Table of Contents
