Siemens SINAMICS G List Manual page 360

Parameters
Parameter list
p9930[0...8] System logbook activation / SYSLOG activation
CU Can be changed: U, T
Data type: Unsigned8
P-Group: -
Min
0
Description: Only for service purposes.
Index: [0] = System logbook stage (0: not active)
[1] = COM2/COM1 (0: COM2, 1: COM1)
[2] = Activate file write (0: not active)
[3] = Display time stamp (0: No display)
[4] = Display system logbook stage (0: No display)
[5] = Display drive object number (0: No display)
[6] = Display software module name (0: No display)
[7] = Output buffer size (in 1 kB stages)
[8] = System logbook file size (in stages, each 10 kB)
Notice: Before powering-down the control unit, ensure that the system logbook is switched-out (p9930[0] = 0).
p9931[0...99] System logbook module selection / SYSLOG mod select.
CU Can be changed: U, T
Data type: Unsigned32
P-Group: -
Min
0000 hex
Description: Only for service purposes.
p9932 Save system logbook EEPROM / SYSLOG EEPROM save
CU Can be changed: U, T
Data type: Unsigned8
P-Group: -
Min
0
Description: Only for service purposes.
p9950 Runtime measurement, control / Runtime_meas ctrl
CU Can be changed: U, T
Data type: Integer16
P-Group: -
Min
0
Description: Controls the runtime measurements.
Values: 0:
1:
2:
3:
Dependency: Refer to: r9976
1-360
Stop runtime measurement
Start runtime meas (internal)
Clear trace buffer (internal)
Activate calculation of remaining computing time
Data set: -
Units group: -
Max
255
Data set: -
Units group: -
Max
FFFF FFFF hex
Data set: -
Units group: -
Max
255
Data set: -
Units group: -
Max
3
 Siemens AG 2004 All Rights Reserved
SINAMICS G List Manual, Edition 12.2004
Access level: 3
Function diagram: -
Unit selection: -
Factory setting
0
Access level: 3
Function diagram: -
Unit selection: -
Factory setting
0000 hex
Access level: 3
Function diagram: -
Unit selection: -
Factory setting
0
Access level: 4
Function diagram: -
Unit selection: -
Factory setting
0