Siemens SINAMICS G List Manual page 64

Parameters
Parameter list
p0295 Fan run-on time / Fan run-on time
VECTOR Can be changed: U, T
Data type: Floating Point
P-Group: Drive converter
Min
0 [s]
Description: Sets the run-on time of the fan after the power module is powered-down.
p0300[0...n] Mot type selection / Mot type selection
VECTOR Can be changed: C2
Data type: Integer16
P-Group: Motor
Min
0
Description: Selects the motor type or start command to download motor parameters from the integrated encoder evaluation
with p0300 = 10000.
The first digit of the parameter value (for p0300 < 10000) always defines the general motor type and corresponds to
the unlisted motor belonging to a motor list:
1 = Rotating induction motor
2 = Rotating synchronous motor (only for servo drives)
3 = Linear induction motor (reserved)
4 = Linear synchronous motor (reserved)
7 = SIEMOSYN motor (only for vector drives)
8 = Reluctance motor (only for vector drives)
The type information must be entered to filter motor-specific parameters and to optimize the operating characteris-
tics and behavior. For example, for synchronous motors, power factor (p0308) is neither used nor displayed (in the
BOP/AOP).
Values: 0:
1:
2:
7:
8:
11:
15:
16:
17:
18:
102:
104:
107:
134:
136:
206:
236:
237:
10000: Motor with DRIVE-CLiQ
Dependency: When the motor type is changed, the code number in p0301 may be reset to 0
Refer to: p0301
1-64
No motor selected
Induction motor (rotating)
Synchronous motor (rotating, permanent-magnet)
SIEMOSYN motor
Reluctance motor
1LA1 standard induction motor
1LA5 standard induction motor
1LA6 standard induction motor
1LA7 standard induction motor
1LA8 standard induction motor
1PH2 induction motor
1PH4 induction motor
1PH7 induction motor
1PM4 induction motor
1PM6 induction motor
1FT6 synchronous motor
1FK6 synchronous motor
1FK7 synchronous motor
Data set: -
Units group: TIME
Max
600 [s]
Data set: MDS
Units group: -
Max
10000
 Siemens AG 2004 All Rights Reserved
SINAMICS G List Manual, Edition 12.2004
Access level: 1
Function diagram: -
Unit selection: -
Factory setting
0 [s]
Access level: 2
Function diagram: 6310
Unit selection: -
Factory setting
0