Siemens SINAMICS G List Manual page 159

Note: The faults are automatically acknowledged after half of the waiting time has expired.
p1213 Automatic restart, monitoring time line supply return / WEA t_mon line sup
VECTOR Can be changed: U, T
Data type: Floating Point
P-Group: Functions
Min
0.0 [s]
Description: Sets the monitoring time of the automatic restart (AR).
Dependency: Refer to: p1210, r1214
Cautiont: A change is only accepted and made if the state "initialization" (r1214.0) and "wait for alarm" (r1214.1).
Note: The monitoring time starts when the faults are detected. If the automatic acknowledgements are not successful, the
monitoring time runs again. If, after the monitoring time has expired, the drive has still not successfully restarted
(the motor must have been magnetized), then fault F07320 is output.
The monitoring is de-activated with p1213 = 0. If p1213 is set lower than the sum of p1212 and the magnetization
time r346, then fault F07320 is generated at each restart.
r1214 CO/BO: Automatic restart, status / AR status
VECTOR Can be changed: -
Data type: Unsigned16
P-Group: Functions
Min
-
Description: Automatic restart (AR) status word.
Bit field: Bit Signal name
00 Initialization
01 Wait for alarm
02 Auto restart act.
04 Acknowledge alarms
05 Restart
06 Wait time running
07 Fault
12 Start count. bit 0
13 Start count. bit 1
14 Start count. bit 2
15 Start count. bit 3
p1215 Motor holding brake configuration / Brake config
VECTOR Can be changed: U, T
Data type: Integer16
P-Group: Functions
Min
0
Description: Sets the holding brake configuration.
Values: 0:
1:
2:
3:
Dependency: Refer to: p1216, p1217, p1226, p1227
 Siemens AG 2004 All Rights Reserved
SINAMICS G List Manual, Edition 12.2004
No motor holding brake being used
Motor holding brake acc. to sequential control
Motor holding brake always open
Motor holding braking can be parameterized via BICO just like the sequential control, brake connection
Data set: -
Units group: TIME
Max
1999.0 [s]
Data set: -
Units group: -
Max
-
0 signal
No
No
No
No
No
No
No
Off
Off
Off
Off
Data set: -
Units group: -
Max
3
Parameters
Parameter list
Access level: 3
Function diagram: -
Unit selection: -
Factory setting
0.0 [s]
Access level: 4
Function diagram: -
Unit selection: -
Factory setting
-
1 signal FP
Yes -
Yes -
Yes -
Yes -
Yes -
Yes -
Yes -
On -
On -
On -
On -
Access level: 2
Function diagram: 2701
Unit selection: -
Factory setting
0
1-159