Siemens SINAMICS G List Manual page 33

Index: [0] = Maximum inverter
[1] = Maximum depletion layer
[2] = Maximum rectifier
[3] = Air intake
[4] = Electronics unit in the power module
[5] = Inverter 1
[6] = Inverter 2
[7] = Inverter 3
[8] = Inverter 4
[9] = Inverter 5
[10] = Inverter 6
[11] = Rectifier 1
[12] = Rectifier 2
[13] = Depletion layer 1
[14] = Depletion layer 2
[15] = Depletion layer 3
[16] = Depletion layer 4
[17] = Depletion layer 5
[18] = Depletion layer 6
Dependency: Refer to: p0290
r0038 Power factor, smoothed / CosPhi smooth
VECTOR Can be changed: -
Data type: Floating Point
P-Group: Displays, signals
Min
-
Description: Displays the smoothed actual power factor.
Note: Smoothing time constant: 100 ms (for active line module and vector drive: 300 ms)
The signal is not suitable as process quantity and may only be used as display quantity.
Significance for the motor: Motor power factor
Significance for the infeed: Power factor at the connection point (p3470, p3471)
r0046 CO/BO: Missing drive enable signals / Drv miss enable
VECTOR Can be changed: -
Data type: Unsigned32
P-Group: Displays, signals
Min
-
Description: Displays missing enable signals that are preventing the closed-loop drive control from being commissioned.
Bit field: Bit Signal name
00 OFF1 enable missing
01 OFF2 enable missing
02 OFF3 enable missing
03 Enable run missing
05 STOP2 enable missing
06 STOP1 enable missing
08 EP terminals enable missing
09 Infeed enable missing
10 Ramp-function generator enable missing
11 Ramp-function generator start missing
12 Setpoint enable missing
 Siemens AG 2004 All Rights Reserved
SINAMICS G List Manual, Edition 12.2004
Data set: -
Units group: -
Max
-
Data set: -
Units group: -
Max
-
0 signal
No
No
No
No
No
No
No
No
No
No
No
Parameters
Parameter list
Access level: 3
Function diagram: 8950
Unit selection: -
Factory setting
-
Access level: 1
Function diagram: 2614
Unit selection: -
Factory setting
-
1 signal FP
Yes -
Yes -
Yes -
Yes -
Yes -
Yes -
Yes -
Yes -
Yes -
Yes -
Yes -
1-33