Siemens SINAMICS G List Manual page 115

Bit field: Bit Signal name
00 DI 0 (X122.1)
01 DI 1 (X122.2)
02 DI 2 (X122.3)
03 DI 3 (X122.4)
04 DI 4 (X132.1)
05 DI 5 (X132.2)
06 DI 6 (X132.3)
07 DI 7 (X132.4)
08 DI/DO 8 (X122.7)
09 DI/DO 9 (X122.8)
10 DI/DO 10 (X122.10)
11 DI/DO 11 (X122.11)
12 DI/DO 12 (X132.7)
13 DI/DO 13 (X132.8)
14 DI/DO 14 (X132.10)
15 DI/DO 15 (X132.11)
Dependency: The simulation of a digital input is selected using p0795.
Refer to: p0795
Note: DI: Digital input
DI/DO: Bidirectional digital input/output
This parameter is not saved when data is backed-up (p0971, p0977).
p0799 CU inputs/outputs, sampling time / CU DI/DO t_sample
CU Can be changed: C1
Data type: Floating Point
P-Group: Commands
Min
0.00 [µs]
Description: Sets the sampling time for the inputs and outputs.
Dependency: The parameter can only be modified for p0009 = 3, 29.
The sampling times can only be set as an integer multiple of the basic sampling time (p0110, p0111).
Refer to: p0009, p0110, p0111
Note: The modified sampling time is not effective until the drive unit is powered-up again.
p0806 BI: Inhibit master control / PcCtrl inhibit
VECTOR Can be changed: T
Data type: Unsigned32
P-Group: Commands
Min
-
Description: Sets the signal source to block the master control.
Dependency: Refer to: r0807
Note: The master control is used from the commissioning software (drive control panel) and from the advanced operator
panel (AOP, local mode).
 Siemens AG 2004 All Rights Reserved
SINAMICS G List Manual, Edition 12.2004
0 signal
Low
Low
Low
Low
Low
Low
Low
Low
Low
Low
Low
Low
Low
Low
Low
Low
Data set: -
Units group: TIME_M6
Max
5000.00 [µs]
Data set: -
Units group: -
Max
-
Parameters
Parameter list
1 signal FP
High -
High -
High -
High -
High -
High -
High -
High -
High -
High -
High -
High -
High -
High -
High -
High -
Access level: 3
Function diagram: 2100,
2120, 2130, 2131, 2132, 2133
Unit selection: -
Factory setting
4000.00 [µs]
Access level: 3
Function diagram: -
Unit selection: -
Factory setting
0
1-115