Siemens SINAMICS G List Manual page 35

r0047 Motor data identification routine and speed controller optimization / MotID and n_opt
VECTOR Can be changed: -
Data type: Integer16
P-Group: Displays, signals
Min
-
Description: Displays the actual status for the motor data identification (standstill measurement) and the speed/velocity control-
ler optimization (rotating measurement).
Values: 0:
120:
140:
150:
170:
190:
200:
210:
220:
230:
240:
270:
290:
300:
r0050 CO/BO: Command data set CDS effective / CDS effective
VECTOR Can be changed: -
Data type: Unsigned8
P-Group: Displays, signals
Min
-
Description: Displays the effective command data set (CDS).
Bit field: Bit Signal name
00 CDS effective, bit 0
01 CDS effective, bit 1
02 CDS effective, bit 2
03 CDS effective, bit 3
Dependency: Refer to: p0810, p0811, p0812, p0813, r0836
Note: The command data set selected via binector inputs p0810, p0811, p0812 and p0813 is displayed via r0836.
r0051 CO/BO: Drive data set DDS effective / DDS effective
VECTOR Can be changed: -
Data type: Unsigned8
P-Group: Displays, signals
Min
-
Description: Displays the effective drive data set (DDS).
Bit field: Bit Signal name
00 DDS eff., bit 0
01 DDS eff., bit 1
02 DDS eff., bit 2
03 DDS eff., bit 3
04 DDS eff., bit 4
Dependency: Refer to: p0820, p0821, p0822, p0823, p0824, r0837
 Siemens AG 2004 All Rights Reserved
SINAMICS G List Manual, Edition 12.2004
No measurement
Vibration test
Calculate speed controller setting
Measurement, moment of inertia and speed controller optimization
Measurement, magnetizing current and saturation characteristic
Speed encoder test
Rotating measurement selected
Rotor position measurement selected
identification, leakage inductance
Identification, rotor time constant
Identification, stator inductance
Identification, stator resistance
Identification, valve lockout time
Standstill measurement selected
Data set: -
Units group: -
Max
-
Data set: -
Units group: -
Max
-
0 signal
Off
Off
Off
Off
Data set: -
Units group: -
Max
-
0 signal
Off
Off
Off
Off
Off
Parameters
Parameter list
Access level: 1
Function diagram: -
Unit selection: -
Factory setting
-
Access level: 2
Function diagram: -
Unit selection: -
Factory setting
-
1 signal FP
On -
On -
On -
On -
Access level: 2
Function diagram: -
Unit selection: -
Factory setting
-
1 signal FP
On -
On -
On -
On -
On -
1-35