Siemens SINAMICS G List Manual page 361

r9976[0...2] Rem comp time / Rem comp time
CU Can be changed: -
Data type: Floating Point
P-Group: -
Min
- [%]
Description: Displays the remaining computation time (min/averaged/max).
For p9950 = 3 the system starts to determine the residual computation time.
The individual values are measured over short time slices and from the measurements, the maximum, the minimum
and the average value are formed and displayed in the appropriate indices of the parameters.
If the system configuration is changed, the measurement must be stopped and re-activated.
Index: [0] = Remaining computation time (min)
[1] = Remaining computation time (averaged)
[2] = Remaining computation time (max)
Dependency: Refer to: p9950
 Siemens AG 2004 All Rights Reserved
SINAMICS G List Manual, Edition 12.2004
Data set: -
Units group: PERCENT
Max
- [%]
Parameters
Parameter list
Access level: 4
Function diagram: -
Unit selection: -
Factory setting
- [%]
1-361