Siemens SINAMICS G List Manual page 234

Parameters
Parameter list
Bit field: Bit Signal name
00 ON/OFF1
01 OC / OFF2
02 OC / OFF3
03 Enable operation
04 Enables the ramp-function generator
05 Start ramp-function generator
06 Enable speed setpoint
07 Acknowledge fault
08 Jog bit 0
09 Jog bit 1
10 Master ctrl by PLC
11 Direction reversal
12 Enable speed controller
13 Motorized potentiometer, raise
14 Motorized potentiometer, lower
15 CDS bit 0
Note: The master control is used from the commissioning software (drive control panel) and from the advanced operator
panel (AOP, local mode).
p2037 PROFIBUS STW1.10 = 0 mode / PB STW1.10=0 mode
VECTOR Can be changed: T
Data type: Integer16
P-Group: Communication
Min
0
Description: Sets the processing mode for PROFIBUS STW1.10 "Control from PLC".
Generally, control world 1 is received with the first PROFIBUS receive word (PZD1) (this is in conformance to the
PROFIdrive profile). The behavior of STW1.10 = 0 corresponds to that of the PROFIdrive profile. For other applica-
tions that deviate from this, the behavior can be adapted using this particular parameter.
Values: 0:
1:
2:
Note: If the STW1 is not transferred according to the PROFIDRIVE profile with PZD1 (with bit 10 "control by the PLC"),
then P2037 should be set to 2.
p2039 Select debug monitor interface / Sel. debug monitor
CU Can be changed: U, T
Data type: Unsigned16
P-Group: Communication
Min
0
Description: The serial interface for the debug monitor is COM1 (X140) or COM2 (internal).
Value = 0: COM2 (internal)
Value = 1: COM1 (X140), PPI is de-activated
Note: A change only becomes effective after a POWER ON.
1-234
Freeze setpoints and continue to process sign-of-life
Freeze setpoints and sign-of-life
Setpoints are not frozen
0 signal
No
No
No
No
No
No
No
No
No
No
No
No
No
No
No
No
Data set: -
Units group: -
Max
2
Data set: -
Units group: -
Max
1
 Siemens AG 2004 All Rights Reserved
SINAMICS G List Manual, Edition 12.2004
1 signal FP
Yes -
Yes -
Yes -
Yes -
Yes -
Yes -
Yes -
Yes -
Yes 3030
Yes 3030
Yes -
Yes -
Yes -
Yes -
Yes -
Yes -
Access level: 3
Function diagram: -
Unit selection: -
Factory setting
0
Access level: 4
Function diagram: -
Unit selection: -
Factory setting
0