Siemens SINAMICS G List Manual page 25

p0004 BOP parameter menu / BOP par_menu
CU Can be changed: C2, T
Data type: Integer16
P-Group: All groups
Min
0
Description: Display filter for BOP20 and AOP for selecting parameters using menu prompting.
Values: 0:
1:
2:
3:
4:
5:
7:
8:
10:
12:
13:
14:
15:
18:
19:
20:
21:
25:
28:
47:
50:
90:
95:
98:
99:
p0007 Backlighting display delay time / Display t_del
CU Can be changed: U, T
Data type: Unsigned32
P-Group: -
Min
0
Description: Sets the delay time to switch-out background lighting.
If no keys are actuated, then the background lighting automatically switches itself off after this time has expired.
Note: p0007 = 0: Background lighting is always switched on (factory setting).
p0009 Device commissioning parameter filter / Dev comm par_filt
CU Can be changed: C1, T
Data type: Integer16
P-Group: All groups
Min
0
Description: Sets the device and basic drive commissioning.
By appropriately setting this parameter, those parameters are filtered that can be written into in the various commis-
sioning steps.
 Siemens AG 2004 All Rights Reserved
SINAMICS G List Manual, Edition 12.2004
All parameters
Displays, signals
Power module
Motor
Encoder/position encoder
Technology, units
Digital inputs/outputs, commands, sequential control
Analog inputs/outputs, terminal strip
Setpoint channel/ramp-fct generator
Functions
V/f control
Control
Data sets
Gating unit, modulator
Motor identification, power module test
Communication
Faults, alarms, monitoring functions
Closed-loop position control
Free function blocks
Trace and function generator
OEM parameter
Topology
Safety Integrated
Command Data Set (CDS)
Drive Data Set (DDS)
Data set: -
Units group: -
Max
99
Data set: -
Units group: -
Max
2
Data set: -
Units group: -
Max
30
Parameters
Parameter list
Access level: 1
Function diagram: -
Unit selection: -
Factory setting
1
Access level: 3
Function diagram: -
Unit selection: -
Factory setting
0
Access level: 1
Function diagram: -
Unit selection: -
Factory setting
1
1-25