Siemens SINAMICS G List Manual page 290

Parameters
Parameter list
p4041 BI: TM31 signal source for terminal DI/DO 11 / TM31 S_src DI/DO11
TM31 Can be changed: U, T
Data type: Unsigned32
P-Group: Commands
Min
-
Description: Sets the signal source for terminal DI/DO 11 (X541.5) of terminal module 31 (TM31).
Note: DI/DO: Bidirectional digital input/output
Prerequisite: The DI/DO must be set as an output (p4028.11 = 1).
p4046 TM31 digital outputs, limit current / TM31 DO limit curr
TM31 Can be changed: T
Data type: Integer16
P-Group: Commands
Min
0
Description: Sets the limit for the total output voltage of terminals X541.1, X541.2, X541.3 and X541.4 (DI/DO 8 ... 11) of termi-
nal module 31 (TM31).
Values: 0:
1:
Dependency: Refer to: p4028
Warning! Since the sum of the output currents at terminals X541.1, X541.2, X541.3 and X541.4 is limited, an overcurrent or
short circuit at one output terminal can cause a dip in the signal at the other terminals.
r4047 TB30 digital outputs status / TB30 DO status
TB30 Can be changed: -
Data type: Unsigned32
P-Group: Commands
Min
-
Description: Displays the status of the digital outputs of the terminal board 30 (TB30).
Bit field: Bit Signal name
00 DO 0 (X481.5)
01 DO 1 (X481.6)
02 DO 2 (X481.7)
03 DO 3 (X481.8)
Note: DO: Digital output
Inversion using p4048 has been taken into account.
r4047 TM31 digital outputs status / TM31 DO status
TM31 Can be changed: -
Data type: Unsigned32
P-Group: Commands
Min
-
Description: Displays the status of the digital outputs of terminal module 31 (TM31).
1-290
0.1 A total current limit DI/DO 8 ... 11
1.0 A total current limit DI/DO 8 ... 11
Data set: -
Units group: -
Max
-
Data set: -
Units group: -
Max
1
Data set: -
Units group: -
Max
-
0 signal
Low
Low
Low
Low
Data set: -
Units group: -
Max
-
 Siemens AG 2004 All Rights Reserved
SINAMICS G List Manual, Edition 12.2004
Access level: 1
Function diagram: 1840,
9562
Unit selection: -
Factory setting
0
Access level: 2
Function diagram: 9560
Unit selection: -
Factory setting
0
Access level: 1
Function diagram: 9102
Unit selection: -
Factory setting
-
1 signal FP
High -
High -
High -
High -
Access level: 1
Function diagram: 9556,
9560, 9562
Unit selection: -
Factory setting
-