Siemens SINAMICS G List Manual page 693

Function diagrams vector control
Control status word 1, 2-459
Control status word 3, 2-460
Current setpoint filter, 2-463
Current/power/torque limits, 2-462
Field weakening characteristic, Id set-
point, 2-465
Field weakening controller, flux controller
for induction motors (p0300 = 1),
2-466
Flux control configuration, 2-458
Interface to the motor module for induction
motors (p0300 = 1), 2-467
Iq and Id controllers, 2-464
Kp_n-/Tn_n adaption, 2-450
Pre-control balancing Reference/accele-
ration model, 2-448
Raw signal and temperature sensing,
2-445
Resonance damping and slip compensati-
on, 2-454
Speed actual value and rotor position sen-
sing, motor encoder (encoder 1), 2-446
Speed control configuration, 2-457
Speed control with/without encoder, 2-449
Speed setpoint, droop, 2-447
Torque setpoint, 2-451
Upper/lower torque limit, 2-461
V/f characteristic and voltage boost, 2-453
V/f control status word 1, 2-456
Vdc_max controller and Vdc_min control-
ler, 2-452, 2-455
Function diagramsTerminal Module 31
Electrically isolated digital inputs
(DI 0 ... DI 3), 2-494
Function Module, 1-14
Fxxxx, 3-510
G
General
Faults and alarms, 3-506
Information about parameters, 1-12
General information
Explanation of the symbols (Part 1), 2-375
Explanation of the symbols (Part 2), 2-376
Explanation of the symbols (Part 3), 2-377
Handling BICO-Technology, 2-378
H
Holdingbrake, 2-425
Hotline, Preface-7
 Siemens AG 2004 All Rights Reserved
SINAMICS G List Manual, Edition 12.2004
I
Index
Factory setting, 1-19
Parameter, 1-13, 1-19
Information
Hotline, Preface-7
Internet Address, Preface-7
Technical Support, Preface-7
Input terminals
Control Unit 320 (CU320), 2-391
Terminal Board 30 (TB30), 2-488
Terminal Module 31 (TM31), 2-493
Internal, 2-410
Internet, Preface-7
J
Jogging, 2-435
L
Linked parameter, 1-13
List
Abbreviations, Abbreviations-675
Parameter ranges, 1-21
References, References-681
List of Abbreviations, Abbreviations-675
List of parameters for
Command data sets, 1-362
Drive data sets, 1-364
Load monitoring (r0108.16 = 1), 2-472
M
Main/supplementary setpoint, 2-435
Manufacturer-specific telegrams, 2-398
MDS, Motor Data Set, 1-17
Missing enable signals
Drive, 2-424
Monitoring functions, 2-472
Motor holding brake, 2-425
Motorized potentiometer, 2-435, 2-470
N
Name
Fault, 3-511
Parameter, 1-14
Warning, 3-511
Number
Fault, 3-510
Parameter, 1-13
Warning, 3-510
Numerical Range
Parameter, 1-21
O
Object, 1-14
Index
Index-693