Siemens SINAMICS G List Manual page 155

Bit field: Bit Signal name
00 Interpolation ramp-fct gen/speed controller
active
01 Interpol. op-loop ctrl /speed controller active No
r1197 Fixed speed setpoint, actual number / n_set_fixed No act
VECTOR Can be changed: -
Data type: Unsigned32
P-Group: Setpoints
Min
-
Description: Displays the number of the selected fixed speed/velocity setpoint.
Dependency: Refer to: p1020, p1021, p1022, p1023
Note: If a fixed speed setpoint has not been selected (p1020 ... p1023 = 0, r1197 = 0), then r1024 = 0 (setpoint = 0).
r1198 CO/BO: Control word setpoint channel / STW setpoint chan
VECTOR Can be changed: -
Data type: Unsigned16
P-Group: Setpoints
Min
-
Description: Displays the control word for the setpoint channel.
Bit field: Bit Signal name
00 Fixed setp. bit 0
01 Fixed setp. bit 1
02 Fixed setp. bit 2
03 Fixed setp. bit 3
05 Inhibit negative direction
06 Inhibit positive direction
11 Direction reversal
13 Motorized potentiometer, raise
14 Motorized potentiometer, lower
15 Bypass ramp-function generator
r1199 CO/BO: Ramp-function generator status word / RFG ZSW
VECTOR Can be changed: -
Data type: Unsigned16
P-Group: Setpoints
Min
-
Description: Displays the status word for the ramp-function generator (RFG).
Bit field: Bit Signal name
00 Ramp-up active
01 Ramp-down active
02 Ramp-function generator active
03 Ramp-function generator set
04 Ramp-function generator held
05 Ramp-function generator tracking active
06 Maximum limit active
Note: Re bit 02:
The bit is an OR logic operation - bit 00 and bit 01.
 Siemens AG 2004 All Rights Reserved
SINAMICS G List Manual, Edition 12.2004
0 signal
No
Data set: -
Units group: -
Max
-
Data set: -
Units group: -
Max
-
0 signal
No
No
No
No
No
No
No
No
No
No
Data set: -
Units group: -
Max
-
0 signal
No
No
No
No
No
No
No
Parameters
Parameter list
1 signal FP
Yes 3080
Yes 3080
Access level: 3
Function diagram: 3010
Unit selection: -
Factory setting
-
Access level: 3
Function diagram: 1530,
2505
Unit selection: -
Factory setting
-
1 signal FP
Yes -
Yes -
Yes -
Yes -
Yes -
Yes -
Yes -
Yes -
Yes -
Yes -
Access level: 3
Function diagram: 1550,
3080, 8010
Unit selection: -
Factory setting
-
1 signal FP
Yes -
Yes -
Yes -
Yes -
Yes -
Yes -
Yes -
1-155