Table of Contents
Advertisement
Parameters
Parameter list
p0369[0...n]
Saturation characteristic I_mag 4 / Mot sat. I_mag 4
VECTOR
Can be changed: C2, U, T
Data type: Floating Point
P-Group: Motor
Min
25.0 [%]
Description:
The saturation characteristics (flux as a function of the magnetizing current) is defined using 4 points.
This parameter specifies the x coordinate (magnetizing current) for the 4th value pair of the characteristic.
Sets the fourth magnetizing current of the saturation characteristic as a [%] referred to the rated magnetizing cur-
rent (p0331).
Dependency:
The following applies for the magnetizing currents:
p0366 < p0367 < p0368 < p0369
Refer to: p0365
r0370[0...n]
Motor stator resistance, cold / Mot R_stator cold
VECTOR
Can be changed: -
Data type: Floating Point
P-Group: Motor
Min
- [Ohm]
Description:
Displays the motor stator resistance at an ambient temperature p0625. The value does not include the cable resis-
tance.
Dependency:
Refer to: p0625
r0372[0...n]
Cable resistance / Mot R_cable
VECTOR
Can be changed: -
Data type: Floating Point
P-Group: Motor
Min
- [Ohm]
Description:
Displays the cable resistance between the motor module and motor.
Dependency:
Refer to: p0352
r0373[0...n]
Motor rated stator resistance / Mot R_stator rated
VECTOR
Can be changed: -
Data type: Floating Point
P-Group: Motor
Min
- [Ohm]
Description:
Displays the rated motor stator resistance at rated temperature (sum from p0625 and p0627).
Dependency:
Refer to: p0627
Note:
The parameter is not used for synchronous motors (p0300 = 2xx).
1-80
Data set: MDS
Units group: PERCENT
Max
500.0 [%]
Data set: MDS
Units group: RESISTANCE
Max
- [Ohm]
Data set: MDS
Units group: RESISTANCE
Max
- [Ohm]
Data set: MDS
Units group: RESISTANCE
Max
- [Ohm]
Siemens AG 2004 All Rights Reserved
SINAMICS G List Manual, Edition 12.2004
Access level: 4
Function diagram: -
Unit selection: -
Factory setting
210.0 [%]
Access level: 4
Function diagram: -
Unit selection: -
Factory setting
- [Ohm]
Access level: 4
Function diagram: -
Unit selection: -
Factory setting
- [Ohm]
Access level: 4
Function diagram: -
Unit selection: -
Factory setting
- [Ohm]
Hide quick links:
Advertisement
Table of Contents
