Siemens SINAMICS G List Manual page 27

p0010 TB30 commissioning parameter filter / TB30 comm.par_filt
TB30 Can be changed: C2, T
Data type: Integer16
P-Group: All groups
Min
0
Description: Sets the parameter filter for commissioning a terminal board 30 (TB30).
Setting this parameter filters-out the parameters that can be written into in the various commissioning steps.
For the BOP, this setting also causes the read access operations to be filtered.
Values: 0:
29:
30:
Dependency: Refer to: p0970
Note: Procedure for "parameter reset": Set p0010 = 30 and p0970 = 1.
p0010 TM31 commissioning parameter filter / TM31 comm par_filt
TM31 Can be changed: C2, T
Data type: Integer16
P-Group: All groups
Min
0
Description: Sets the parameter filter for commissioning a terminal module 31 (TB31).
Setting this parameter filters-out the parameters that can be written into in the various commissioning steps.
For the BOP, this setting also causes the read access operations to be filtered.
Values: 0:
29:
30:
Dependency: Refer to: p0970
Note: Only the following values are possible: p0010 = 0, 30
Procedure for "parameter reset": Set p0010 = 30 and p0970 = 1.
p0015 Macro drive unit / Macro drv unit
CU Can be changed: C1
Data type: Unsigned32
P-Group: -
Min
0
Description: Runs the appropriate ACX file on the CompactFlash Card.
The selected ACX file must be located in the following directory:
... /PMACRO/DEVICE/P15/PMxxxxxx.ACX
Example:
p0015 = 6 --> the file PM000006.ACX is run.
Dependency: The ACX file to be run must be created according to the definition for ACX macros and must be saved in the direc-
tory intended on the CompactFlash Card.
Refer to: p0015, p0700, p1000, p1500
 Siemens AG 2004 All Rights Reserved
SINAMICS G List Manual, Edition 12.2004
Ready
Download
Parameter reset
Ready
Download
Parameter reset
Data set: -
Units group: -
Max
30
Data set: -
Units group: -
Max
30
Data set: -
Units group: -
Max
999999
Parameters
Parameter list
Access level: 1
Function diagram: -
Unit selection: -
Factory setting
0
Access level: 1
Function diagram: -
Unit selection: -
Factory setting
0
Access level: 1
Function diagram: -
Unit selection: -
Factory setting
0
1-27