Siemens SINAMICS G List Manual page 18

Parameters
Overview of parameters
P group (refers only to access via BOP (Basic Operator Panel))
Specifies the functional group to which the parameter belongs. The required
parameter group can be set via p0004.
Note:
Parameter p0004 is CU-specific (belongs to control unit).
Unit, unit group and unit choice
The following applies to parameters with a unit:
• Each of these parameters is assigned to a unit group.
• The relevant unit for the parameter is specified in square parenthesis.
• If the parameter unit can be set within the unit group, then the parameters
required to do so are specified under "Unit choice".
Note:
References: /IH1/
Parameter values
Min
Max
Factory Setting
Description
Explanation of the function of a parameter.
Values
Lists the possible values of a parameter.
Recommendation
Information about recommended settings.
1-18
SINAMICS S120 Commissioning Manual
in section "Units"
Minimum value of the parameter [unit]
Maximum value of the parameter [unit]
Shipped value (default) [unit]
A different value may be displayed for certain parameters
(e. g. p1800) at the initial commissioning stage.
Reason:
The setting of these parameters is determined by the
operating environment of the Control Unit
(e. g. depending on converter type, macro, power mod-
ule).
 Siemens AG 2004 All Rights Reserved
SINAMICS G List Manual, Edition 12.2004