Siemens SINAMICS G List Manual page 695

Torque messages/signals, 2-472
U
U - status Run, 1-15
Unit (Parameter), 1-18
V
V/f control
Vector, 2-453
Values (Parameter), 1-18
Vector control
Contents, 2-444
Current setpoint filter, 2-463
Droop, 2-447
Field weakening characteristic, Id set-
point, 2-465
Flux control, 2-458
Iq and Id controllers, 2-464
Kp_n-/Tn_n adaption, 2-450
Resonance damping and slip compensati-
on, 2-454
Speed actual value and rotor position sen-
sing, 2-446
Speed control configuration, 2-457
Speed control with/without encoder, 2-449
Torque setpoint, 2-451
V/f characteristic, 2-453
V/f control status word 1, 2-456
Vdc_max controller and Vdc_min control-
ler, 2-455
 Siemens AG 2004 All Rights Reserved
SINAMICS G List Manual, Edition 12.2004
Version
List of parameters for command data sets,
1-362
List of parameters for drive data sets,
1-364
Visualization parameters, 1-13
W
Warning
Cause, 3-511
Display, 3-506
Explanation of List, 3-510
Fault location, 3-511
General, 3-506
How to Distinguish from a Fault, 3-506
Name, 3-511
Number, 3-510
Remedy, 3-512
Index
Index-695