Siemens SINAMICS G List Manual page 51

p0124[0...15] Detection of main components using LED / Detection LED
CU Can be changed: U, T
Data type: Unsigned8
P-Group: Drive converter
Min
0
Description: Detects the main components of the drive object selected via the index.
p0124[0...n] Power module detection via LED / LT detection LED
VECTOR Can be changed: U, T
Data type: Unsigned8
P-Group: Drive converter
Min
0
Description: Detects the power module assigned to this drive and data set.
Note: While p0124 = 1, the READY LED flashes green/orange or red/orange with 2 Hz at the appropriate power module.
For parallel circuit configurations, the parameter index is assigned to a power module.
r0127[0...n] Power module version EPROM data / PM EPROM version
VECTOR Can be changed: -
Data type: Unsigned32
P-Group: Drive converter
Min
-
Description: Displays the version of the EPROM data of the power module.
Dependency: Refer to: r0147, r0157
Note: For parallel circuit configurations, the parameter index is assigned to a power module.
r0128[0...n] Power module firmware version / LT FW_version
VECTOR Can be changed: -
Data type: Unsigned32
P-Group: Drive converter
Min
-
Description: Displays the power module firmware version.
Dependency: Refer to: r0018, r0148, r0158, r0197, r0198
Note: Example:
The value 1010100 should be interpreted as V01.01.01.00.
For parallel circuit configurations, the parameter index is assigned to a power module.
p0130 Motor data sets (MDS) number / MDS quantity
VECTOR Can be changed: C1
Data type: Unsigned8
P-Group: Data sets
Min
1
Description: Sets the number of motor data sets (MDS).
Dependency: This parameter is only relevant for servo and vector drives (see p0107).
 Siemens AG 2004 All Rights Reserved
SINAMICS G List Manual, Edition 12.2004
Data set: -
Units group: -
Max
1
Data set: PDS
Units group: -
Max
1
Data set: PDS
Units group: -
Max
-
Data set: PDS
Units group: -
Max
-
Data set: -
Units group: -
Max
1
Parameters
Parameter list
Access level: 2
Function diagram: -
Unit selection: -
Factory setting
0
Access level: 2
Function diagram: -
Unit selection: -
Factory setting
0
Access level: 3
Function diagram: -
Unit selection: -
Factory setting
-
Access level: 3
Function diagram: -
Unit selection: -
Factory setting
-
Access level: 2
Function diagram: -
Unit selection: -
Factory setting
1
1-51