Neighbor Timers - Dell S4810 Reference Manual

Hide thumbs Also See for S4810:

Table of Contents

show ip bgp neighbors

neighbor timers

Set keepalive and hold time timers for a BGP neighbor or a peer group.

neighbor {ip-address | peer-group-name} timers keepalive

To return to the default values, use the no neighbor {ip-address | peer-

group-name} timers command.

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 9.0.2.0

Version 8.3.11.1

Version 8.3.7.0

Border Gateway Protocol

NOTE: This command is supported in BGP Router Configuration mode for

IPv4 Unicast address only.

— displays routes received by a neighbor.

Enter the IP address of the peer router in dotted decimal

Enter the name of the peer group to set the timers for all

routers within the peer group.

Enter a number for the time interval, in seconds, between

keepalive messages sent to the neighbor routers. The range

is from 1 to 65535. The default is 60 seconds.

Enter a number for the time interval, in seconds, between

the last keepalive message and declaring the router dead.

The range is from 3 to 65535. The default is 180 seconds.

keepalive = 60 seconds

holdtime = 180 seconds

Introduced on the S6000.

Introduced on the S4820T.

Introduced on the Z9000.

Introduced on the S4810.