Network - Dell S4810 Reference Manual

Usage
In the Dell Networking OS best path selection process, the path with the highest
Information
weight value is preferred.
If you configure the set weight command in a route map applied to this
neighbor, the weight set in that command overrides the weight set in the
neighbor weight command.
Related set weight
Commands

network

Specify the networks for the BGP process and enter them in the BGP routing table.
S4810
Syntax
network ip-address mask [route-map map-name]
To remove a network, use the no network ip-address mask [route-map
map-name] command.
Parameters
ip-address
mask
route-map
map-name
440
NOTE: In the Dell Networking OS best-path selection process, the path with
the highest weight value is preferred.
— assigns a weight to all paths meeting the route map criteria.
Enter an IP address in dotted decimal format of the network.
Enter the mask of the IP address in the slash prefix length
format (for example, /24).
The mask appears in command outputs in dotted decimal
format (A.B.C.D).
(OPTIONAL) Enter the keyword route-map then the name
of an established route map.
Only the following ROUTE-MAP mode commands are
supported:
• match ip address
• set community
• set local-preference
• set metric
• set next-hop
• set origin
• set weight
If the route map is not configured, the default is deny (to
drop all routes).
Border Gateway Protocol