Neighbor Activate - Dell S4810 Reference Manual

ibgp
number
Defaults none
Command ROUTER BGP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.8.0
Version 8.3.7.0
Version 7.8.1.0
Version 7.7.1.0
Usage If you enable this command, use the clear ip bgp * command to recompute
Information the best path.

neighbor activate

This command allows the specified neighbor/peer group to be enabled for the current AFI/SAFI (Address
Family Identifier/Subsequent Address Family Identifier).
S4810
Syntax
neighbor [ip-address | peer-group-name] activate
To disable, use the no neighbor [ip-address | peer-group-name]
activate command.
Parameters
ip-address
peer-group-
name
activate
412
Enter the keyword ibgp to enable multipath support for
Internal BGP routes.
Enter a number as the maximum number of parallel paths.
The range is from 2 to 64.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Support from 2 to 64 paths on the S4810. Command syntax
changed to max-path (was maximum-paths).
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
(OPTIONAL) Enter the IP address of the neighbor in dotted
decimal format.
(OPTIONAL) Enter the name of the peer group.
Enter the keyword activate to enable the neighbor/peer
group in the new AFI/SAFI.
Border Gateway Protocol