Dell S4810 Reference Manual page 364

To disable BFD for all neighbors configured through static routes, use the no ip
route bfd [interval interval min_rx min_rx multiplier value
role {active | passive}] command.
Parameters
interval
milliseconds
min_rx
milliseconds
multiplier value
role [active |
passive]
Defaults See Parameters
Command CONFIGURATION
Modes
Command
Version 9.3.
History
(0.0)
Version 9.2.
(0.0)
Version 8.2.1.0
Version 7.6.1.0
Version 7.4.1.0
364
(OPTIONAL) Enter the keywords interval to specify non-
default BFD session parameters beginning with the
transmission interval. The range is from 50 to 1000. The
default is 100.
Enter the keywords min_rx to specify the minimum rate at
which the local system receives control packets from the
remote system. The range is from 50 to 1000. The default is
100.
Enter the keywords multiplier to specify the number of
packets that must be missed in order to declare a session
down. The range is from 3 to 50. The default is 3.
Enter the role that the local system assumes:
• Active — The active system initiates the BFD session.
Both systems can be active for the same session.
• Passive — The passive system does not initiate a
session. It only responds to a request for session
initialization from the active system.
The default is Active.
Introduced on S6000.
Introduced on Z9000, S4810, and S4820T.
Introduced on the E-Series ExaScale.
Introduced on the C-Series.
Introduced on the E-Series.
Bidirectional Forwarding Detection (BFD)