Ip Max-Frag-Count - Dell Force10 Z9000 Reference Manual

Defaults Not configured.
Command Modes CONFIGURATION
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.0

ip max-frag-count

Set the maximum number of fragments allowed in one packet for packet re-assembly.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax ip max-frag-count count
To place no limit on the number of fragments allowed, use the no ip max-frag-count
command.
Parameters
count
Defaults No limit is set on number of fragments allowed.
Command Modes CONFIGURATION
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.0
Usage To avoid denial of service (DOS) attacks, keep the number of fragments allowed for re-
Information assembly low.
790
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced for the E-Series.
Enter a number for the number of fragments allowed for re-assembly.
The range is 2 to 256.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced for the E-Series.