Debug Ip Bgp Ipv6 Unicast Soft-Reconfiguration - Dell S4810 Reference Manual

in
out
Command EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Version 8.4.1.0
Version 7.8.1.0
Version 7.7.1.0
Version 7.2.1.0

debug ip bgp ipv6 unicast soft-reconfiguration

Enable soft-reconfiguration debugging for IPv6 unicast routes.
S4810
Syntax
debug ip bgp [ipv4-address | ipv6-address | peer-group-name]
ipv6 unicast soft-reconfiguration
To disable debugging, use the no debug ip bgp [ipv4-address | ipv6-
address | peer-group-name] ipv6 unicast soft-reconfiguration
command.
Parameters
ipv4-address |
ipv6-address
peer-group-
name
ipv6 unicast
Defaults Disabled.
492
Reapply only inbound policies.
NOTE: If you enter soft, without an in or out option,
both inbound and outbound policies are reset.
Reapply only outbound policies.
NOTE: If you enter soft, without an in or out option,
both inbound and outbound policies are reset.
Introduced on the S4820T.
Added support for IPv4 multicast and IPv6 unicast routes.
Introduced on the S4810.
Introduced on the C-Series.
Introduced on the E-Series TeraScale.
Enter the IP address of the neighbor on which you want to
enable soft-reconfiguration debugging.
Enter the name of the peer group on which you want to
enable soft-reconfiguration debugging.
Debug soft reconfiguration for IPv6 unicast routes.
Border Gateway Protocol