Dell S4810 Reference Manual page 398

Parameters
vrf vrf-name
*
as-number
ip-address
flap-statistics
soft
in
out
<1-429496729
5>
<0.1-65535.65
535>
A.B.C.D
X:X:X:X::X
398
Enter the keyword vrf and then the name of the VRF to
clear all BGP sessions corresponding to that VRF.
NOTE: Use this attribute to clear a BGP instance
corresponding to either a specific address family in a
default VRF or an IPv4 address family in a a non-default
VRF.
Enter an asterisk ( * ) to reset all BGP sessions.
Enter the AS number to reset all neighbors belonging to that
AS. The range is from 0 to 65535 (2 byte), from 1 to
4294967295 (4 byte), or from 0.1 to 65535.65535 (dotted
format).
Enter an IP address in dotted decimal format to reset all
prefixes from that neighbor.
(OPTIONAL) Enter the keyword flap-statistics to reset
the flap statistics on all prefixes from that neighbor.
(OPTIONAL) Enter the keyword soft to configure and
activate policies without resetting the BGP TCP session, that
is, BGP Soft Reconfiguration.
NOTE: If you enter the clear ip bgp ip-address
soft command, both inbound and outbound policies
are reset.
(OPTIONAL) Enter the keyword in to activate only inbound
policies.
(OPTIONAL) Enter the keyword out to activate only
outbound policies.
NOTE: You must execute the clear ip bgp soft
out command when ever there is a change in the local
policy. If you do not run this command after a local
policy change, then these policy changes are not
reflected in the responses to the peer's route refresh
messages.
Enter <1-4294967295> to clear peers with the AS number.
Enter <0.1-65535.65535> to clear peers with the AS number
in dot format.
Enter the BGP neighbor address in the A.B.C.D format to
clear.
Enter the BGP neighbor address in the X:X:X:X::X format to
clear.
Border Gateway Protocol