Dell S4810 Reference Manual page 388

reuse
suppress
max-suppress-
time
route-map
map-name
Defaults Disabled.
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.7.1.0
Usage
If you enter the bgp dampening command, the default values for half-life,
Information
reuse, suppress, and max-suppress-time are applied. The parameters are
position-dependent; therefore, if you configure one parameter, configure the
parameters in the order they appear in the CLI.
Route refresh is sent when you enable BGP dampening.
388
(OPTIONAL) Enter a number as the reuse value, which is
compared to the flapping route's Penalty value. If the Penalty
value is less than the reuse value, the flapping route is once
again advertised (or no longer suppressed). The range is from
1 to 20000. The default is 750.
(OPTIONAL) Enter a number as the suppress value, which is
compared to the flapping route's Penalty value. If the Penalty
value is greater than the suppress value, the flapping route is
no longer advertised (that is, it is suppressed). The range is
from 1 to 20000. The default is 2000.
(OPTIONAL) Enter the maximum number of minutes a route
can be suppressed. The default is four times the half-life
value. The range is from 1 to 255. The default is 60 minutes.
(OPTIONAL) Enter the keyword route-map then the name
of a configured route map.
Only match commands in the configured route map are
supported.
ROUTER BGP
ROUTER BGP-address-family
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Border Gateway Protocol