Bgp Cluster-Id - Dell S4810 Reference Manual

Defaults Enabled when a route reflector is configured.
Command ROUTER BGP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.7.1.0
Usage Route reflection to clients is not necessary if all client routers are fully meshed.
Information
Related

bgp cluster-id

Commands
neighbor route-reflector-client
bgp cluster-id
Assign a cluster ID to a BGP cluster with more than one route reflector.
S4810
Syntax
bgp cluster-id {ip-address | number}
To delete a cluster ID, use the no bgp cluster-id {ip-address | number}
command.
Parameters
ip-address
number
Defaults Not configured.
Command ROUTER BGP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Border Gateway Protocol
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
— assigns an ID to a BGP cluster with two or more route reflectors.
— configures a route reflector and clients.
Enter an IP address as the route reflector cluster ID.
Enter a route reflector cluster ID as a number from 1 to
4294967295.
383